Pounding a round peg in a hex hole
You have to start by vacuuming the tools. Every two years or so... |
The setup for milling the round stock. |
Diving right in and cutting a flat on the rod. |
Test fitting a wheel. |
Well, it fits. But not very well. |
Here is a closeup. Not quite right. |
It gets setup for the second time. |
Alan gets serious about measuring this time. |
Look at that concentration. He is so good he can turn both knobs at once! |
Another test fitting. Fits much better this time. |
Hey, just like downtown. |
Parting off 4 pieces. |
Here are 2 pieces on a diagram of the assembly. |